все хорошо!
Информация о работе
Подробнее о работе
CONDUCTORS AND INSULATOR 1. Просмотрите текст и найдите в нем все формы ПАССИВНОГО ЗАЛОГА, выделите маркером в распечатанном варианте. 2. Прочитайте
- 4 страниц
- 2021 год
- 0 просмотров
- 0 покупок
Гарантия сервиса Автор24
Уникальность не ниже 50%
Фрагменты работ
CONDUCTORS AND INSULATOR
1. Просмотрите текст и найдите в нем все формы ПАССИВНОГО ЗАЛОГА, выделите маркером в распечатанном варианте.
2. Прочитайте текст. Переведите на русский язык. Используйте слова при переводе текста.
tower – опора, вышка
porcelain insulator – фарфоровый изолятор
to withstand heavy loading – выдерживать большую нагрузку
tears – разрывы
pin-type/post-type insulator – штыревой изолятор
petticoat – нижняя “юбка”
suspension insulator – подвесной изолятор
strain insulator – натяжной изолятор
spool – катушка
Line conductors are electrically insulated from each other as well as from the pole by nonconductors, which are called insulators. To determine whether or not an insulator can be used, both its mechanical strength and electrical properties must be considered. Two practical insulator materials are porcelain and glass.
Porcelain can withstand heavy loading in compression, but tears apart easily under tension, that is, when pulled apart. The same is generally true of glass. Although glass insulators are good for lower voltage application, porcelain insulators are much more widely used because they are more practical. Porcelain has two advantages over glass: 1) it can withstand greater differences in temperature that is, it will not crack when suspected to very high or very low temperature; 2) porcelain is not as brittle as glass and will not break as easily in handling or during installation. Polymer insulators are not so restricted and have the advantage also of being lighter in weight than porcelain or glass.
Pin-type insulators, in compression, supporting conductors may be classified as pin type and post type. Made of porcelain or glass, the pin insulator can weigh anywhere from ½ pound to 90 pounds. This type of insulator is applicable for rural and urban distribution circuit, and it is usually constructed as one solid piece of porcelain or glass. Laager, stronger pin – type insulators are used for light-voltage transmission lines.
Post-type insulators are generally used for higher voltage applications. They may be mounted horizontally as well as vertically, although their strength is diminished when mounted horizontally. The insulator is made of one piece of porcelain and mounting bolt or bracket is an integral part of insulator.
The main advantage of the pin or post-type insulator is that it is cheaper, Also, the pin or post insulator requires a shorter pole to achieve the same conductor above the cross arm. Post-type insulators are also used to support conductors of a polyphaser primary circuit without use of cross arm. This type of installation is employed where appearance or narrow rights-of-way considerations are important.
Форма заказа новой работы
Не подошла эта работа?
Закажи новую работу, сделанную по твоим требованиям
